While reviewing vehicles, the actual data should be considered as real fuel consumption. These data were compiled from sources published by the official and nonofficial websites and catalogues of brands and companies. It is expected to consume 47 percent more fuel than factory data in real conditions and during test drives.Īctual fuel consumption for vehicles is specified in 'Factory data' table. Grand Cherokee 3.0 CRD Automatic real World MPG/consumption is 15,3 lt/100km. The vehicle’s emission standard is Euro 4 III.Īnd combined fuel economy is 10.2 lt/100km according to officially published data by manufacturers. Top speed of the vehicle is 200 km/h (124 mph) The acceleration time from zero to 100 km/h (60 mph) is 9.0 seconds. Transmission is provided by a 5 speed Automatical gearbox with AWD wheel drive. This 2987 cc engine size produces 218 horsepower with 510 Nm torque.
Grand Cherokee 3.0 CRD Automatic is powered by a 3,0 l Diesel engine. Weight of the vehicle is 2210 kg with 540 liters trunk loading capacity. Grand Cherokee Grand Cherokee is a 5 doors SUV in E class / Executive car.
There's plenty of room for the factory single exhaust, and the rear axle is miles away from the back of the tank, so if we ever do get a wild itch to add 1-ton axles or huge dual exhaust in this Jeep we know we won't have to make fuel tank modifications to accomplish it.2006 Jeep Grand Cherokee 3.0 CRD is first presented in 2005 and proceeded in 20. But until then, we have the tank up and held in place with four of the eight mounting holes, and we're pleased to say the fit is perfect with no interference at the bottom of the floor. We'll have to drop the tank one more time to finish hooking up our fuel system after the engine swap begins, so we're going to wait until that time to hook up the filler and vent as well as welding the nuts to the inside of the frame to make install and removal much easier.
Then, we pulled the tank back out and finished drilling the holes and then bolted the tank back in. Once it was up tight into place, we measured each side to make sure the tank was centered side to side and from the rear crossmember and then drilled eight small pilot holes through the frame at the center of each tank bracket.